SMC-EZ1026DT V.2
10
direct sunlight, heat source, and high amount of electromagnetic
interference around.
Mounting tools: If you intend to mount the Switch on a rack,
make sure you have all the tools, mounting brackets, screws etc.
Caution:
Cabling must be away from sources of electrical noise such as
radio, computers, transmitters, broadband amplifiers, power
lines and keep away from TVs, hair dryers, and microwave.
Airflow around the Switch and through its vents on the rear
cannot be restricted.
3.2 Mounting the Switch
The SMC-EZ1026DT V.2 Switch is suitable for use in an office
environment where it can be rack-mounted in standard EIA 19-inch
racks or standalone.
Desktop Mounting
1. Set the Switch on a sufficiently large flat space with a power
outlet nearby, and about the center of all networked devices.
2. Make sure mounting surface on the bottom of the Switch is
grease dust free.
3. Remove adhesive backing from your Rubber Feet.
Figure 3-1. Attaching Rubber Feet to each corner
on the bottom of the Switch
To Next Page
Loading...
Need help?
General
