6.2 Alarm list and description
This paragraph gives a description of a wide range of possible alarms which may occur
during the operation, as well as an explanation of their causes and possible remedies.
The table below is intended to help the reader find a specific alarm in the pages which
follow:
Alarm quick reference table
EyePlus code Name See page
1 Maximum battery voltage 39
2 Minimum battery voltage 39
6 Capacitors not charged 40
11 Capacitors too charged at start Errore:
8, 24 Panel overcurrent alarm 40
12 Low battery alarm 41
15, 36 Motor current sensor alarm 41
17 Main breaker fault 41
20 Panel overtemperature 42
13 Drive motor overtemperature 42
37 Alarm on 5V voltage 42
38 Alarm on 12V output voltage 43
3 Throttle input fault 43
50 Pump motor commands active on start 44
63 Seat switch open on start 44
64 Wrong start 44
74 Encoder alarm 45
18 Watchdog timer alarm 45
5 EEPROM alarm 45
83 CRC fault alarm 46
84 Bank CRC restored 46
This is a general list of possible alarms, but their actual meaningfulness
depends on the specific application.
In particular some AC-M1 applications control one drive motor, other
applications control one pump motor.
PRELIMINARY VERSION 38
To Next Page
Loading...
Need help?
General
