38 (E)
Chapter 2 Menu
Setting Lists of the REMOTE Menu
This section explains the setting lists displayed in the
menu.
How to read the setting lists
•For purposes of explanation, each setting list is
preceded by a menu number. These numbers are not
displayed on the screen.
For more information about the menu number, see “About
menu numbers” on page 26(E).
•The arrow mark (÷) refers you to another setting list
that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, the menu does not have
any sub-list.
[D] REMOTE menu
Select the type of remote control.
SERIAL REMOTE : Set the address and group
number of the monitor controlled via the SERIAL
REMOTE connector. ÷[D1]
PARALLEL REMOTE: Select whether parallel
remote control will be used or not (ON or OFF.)
PARALLEL REMOTE CONFIG : Set the pin
assignments for the PARALLEL REMOTE
connector. ÷[D2]
[D1] SERIAL REMOTE menu
Set the monitor address and group number.
MONITOR ADDRESS: Enter a number.
GROUP ADDRESS: Enter a number.
[D2] PARALLEL REMOTE CONFIG menu
Select the PARALLEL REMOTE connector pins for
which you want to change the function. The factory
settings for each pin are given below. ÷[D211]
PINs 1 to 4, and PIN 6 of the PARALLEL REMOTE
1 and 2 are common settings.
1 PIN: CH01
2 PIN: CH02
3 PIN: TALLY RED
4 PIN: TALLY GREEN
5 PIN: EXT SYNC (PARALLEL REMOTE [1])
GND (PARALLEL REMOTE [2])
6 PIN: UNDERSCAN
7 PIN: 16:9
8 PIN: 4:3 MARKER
Note
PINs 1 to 4, and PIN 6 of the PARALLEL REMOTE
1 and 2 are connected inside the unit, therefore
different functions cannot be assigned to those pins.
[D211] (1/2) 1-8 PIN menu (1/2)
Assign a function to the selected pin.
CH: Select a channel number. Enter the desired
channel number with the numeric keypad.
----: Set to unused.
UNDER SCAN: Set underscan on or off.
16:9: Set a 16:9 aspect ratio on or off.
H DELAY: Set the horizontal sync display on or off.
V DELAY: Set the vertical sync display on or off.
EXT SYNC: Set the synchronization to external sync
signals enabled or disabled.
APERTURE: Set the correction of frequency
characteristics enabled or disabled.
MONO: Set monochrome display on or off.
BLUE ONLY: Set the blue signal pictures display
(monochrome) on or off.
[D211] (2/2) 1-8 PIN menu (2/2)
Assign a function to the selected pin.
R OFF: Set cutting red beams enabled or disabled.
G OFF: Set cutting green beams enabled or disabled.
B OFF: Set cutting blue beams enabled or disabled.
4:3 MARKER: Set the 4:3 marker display on or off.
CAPTION VISION: Set Caption Vision on or off.
TALLY RED: Set tally red on or off.
TALLY GREEN: Set tally green on or off.
DEGAUSS: Set degaussing on or off.
POWER OFF: Set the monitor power on or off.
For the pin assignment, see “PARALLEL REMOTE 1/2
connectors” in the Location and Function of Parts on page
13(E) for BVM-D9H1U/D9H1E/D9H1A/D9H5U/D9H5E/
D9H5A or page 22(E) for BVM-D14H1U/D14H1E/
D14H1A/D14H5U/D14H5E/D14H5A.
D Assigning the Remote Control Functions — REMOTE Menu
To Next Page
Loading...
Need help?
General