Using the Menu
72
INT. REC-STL
This function is useful to observe the movement of clouds or the change of
daylight. Your camcorder will shoot a still image at a selected interval and record
it on a “Memory Stick.”
a: Shooting time
b: Interval
1 Touch .
2 Select a desired interval time (1, 5, or 10 minutes), then touch .
3 Touch [ON], then touch .
4 Touch .
flashes.
5 Press PHOTO fully.
stops flashing and the Interval photo recording starts.
To cancel interval photo recording, select [OFF] in step 3.
DEMO MODE
When you remove a cassette or “Memory Stick” from your camcorder, and select
the CAMERA-TAPE mode, you can view the demonstration in about 10 minutes.
b Note
• You can view the demonstration only when the NIGHTSHOT/NIGHTFRAMING switch
is set to z (green).
z
Tips
• The demonstration will be suspended in situations such as those described below.
– When you touch the screen during the demonstration. (The demonstration starts again in
about 10 minutes.)
– When a cassette or “Memory Stick” is inserted.
– When a mode other than CAMERA-TAPE is selected.
• If [A.SHUT OFF] is set to [5 min] when the camcorder is used on the battery pack, the
power will be turned off after approximately 5 minutes (p. 81).
GOFF To deactivate interval recording.
ON
( ) To record still images on a “Memory Stick” in the selected
interval.
GON
Select to see an overview of the functions available such as when you
are using this camcorder for the first time.
OFF Select when you do not intend to use the DEMO MODE.
[b]
[b]
[a] [a] [a]
To Next Page
Loading...
Need help?
General