178
Identifying the parts and controls
Remote Commander
The buttons that have the same name on the Remote Commander as on your camcorder
function identically to the buttons on your camcorder.
To prepare the Remote Commander
Insert 2 size AA (R6) batteries by matching the + and – polarities on the batteries to
the + – marks inside the battery compartment.
Notes on the Remote Commander
•Point the remote sensor away from strong light sources such as direct sunlight or
overhead lighting. Otherwise, the Remote Commander may not function properly.
•Your camcorder works in the Commander mode VTR 2. Commander modes
1, 2 and 3 are used to distinguish your camcorder from other Sony VCRs to avoid
remote control misoperation. If you use another Sony VCR in the Commander mode
VTR 2, we recommend changing the Commander mode or covering the sensor of the
VCR with black paper.
1 PHOTO button (p. 38, 112)
2 DISPLAY button (p. 32)
3 SEARCH MODE button (p. 61, 62, 64)
4 ./> buttons (p. 61, 62, 64)
5 Tape transport buttons (p. 33)
6 Transmitter
Point toward the remote sensor to
control the camcorder after turning on
the camcorder.
7 ZERO SET MEMORY button (p. 60, 83)
8 START/STOP button (p. 21)
9 DATA CODE button (p. 32)
0 Power zoom button (p. 24)
1
6
7
8
9
q;
2
3
4
5
To Next Page
Loading...
Need help?
General