205
Viewing Images on Your Computer
Connecting your camcorder to your
computer using the USB cable
When connecting to a computer using the USB cable
You must install a USB driver onto your computer in order to connect the camcorder to
the computer’s USB connector. The USB driver can be found on the CD-ROM supplied,
along with the application software required for viewing images.
System requirements
OS:
Mac OS 8.5.1/8.6/9.0/9.1/9.2 or Mac OS X (v10.0/v10.1)
Standard installation is required.
However, note that upgrade to Mac OS 9.0/9.1 should be used for the following
models:
– iMac with the Mac OS 8.6 standard installation and a slot loading type CD-ROM drive
– iBook or Power Mac G4 with the Mac OS 8.6 standard installation
Others:
The USB connector must be provided as standard.
QuickTime 3.0 or later must be installed to play back moving pictures.
Notes
•Operations are not guaranteed for the Macintosh environment if you connect two or
more USB equipment to a single computer at the same time, or when using a hub.
•Some equipment may not operate depending on the type of USB equipment that is
used simultaneously.
•Operations are not guaranteed for all the recommended computer environments
mentioned above.
To Next Page
Loading...
Need help?
General
