94
Using the A/V connecting cable
You can dub or edit on the VCR connected to your camcorder using your camcorder as
a player.
Before operation
•Set DISPLAY to LCD in the menu settings. (The default setting is LCD.)
•Press the following buttons to make the indicators disappear so that they will not be
superimposed on the edited tape:
– DATA CODE on the Remote Commander
– SEARCH MODE on the Remote Commander
– DISPLAY
(1) Insert a tape for recording into the VCR, and insert the recorded tape into your
camcorder.
(2) Prepare the VCR for recording, then set the input selector to LINE.
Connect the A/V connecting cable to the AUDIO/VIDEO jack. Refer to the
operating instructions of your VCR.
(3) Set the POWER switch to VCR/PLAYER.*
(4) Play back the recorded tape on your camcorder.
(5) Start recording on the VCR.
Refer to the operating instructions of your VCR.
— Editing —
Dubbing a tape
S VIDEO OUTS VIDEO
AUDIO/
VIDEO
A/
V OUT
S VIDEO
VIDEO
AUDIO
IN
White
Red
Yellow
: Signal flow
A/V connecting cable
(supplied)
VCR
* Modes on the POWER switch vary depending on models (p. 16).
To Next Page
Loading...
Need help?
General
