82
You can insert a scene in the middle of a recorded tape by setting the start and end
points. The previously recorded frames between these start and end points will be
erased.
Use the Remote Commander for this operation.
(1) In the standby mode, keep pressing EDITSEARCH, and release the button at
the insert end point [b].
(2) Press ZERO SET MEMORY on the Remote Commander.
The ZERO SET MEMORY indicator flashes and the counter resets to zero.
(3) Keep pressing the – 7 side of EDITSEARCH and release the button at the
insert start point [a].
(4) Press START/STOP to start recording.
The scene is inserted. Recording stops automatically near the counter zero
point. Your camcorder returns to the standby mode.
The zero set memory function is canceled.
Inserting a scene
[a]
[b]
EDITSEARCH
ZERO SET
MEMORY
Notes
•The zero set memory function does not work with tapes recorded in the Hi8 /
standard 8 mm system.
•The picture and the sound may be distorted at the end of the inserted section when it
is played back.
If a tape has a blank portion between recorded portions
The zero set memory function may not work correctly.
To Next Page
Loading...
Need help?
General
