Preparations 2-1
Chapter 2 Preparations
2-1 Power Preparations
Chapter 2 Preparations
This unit can be powered by batteries
or AC power.
Note
If you attach or remove batteries or
AC adaptors incorrectly, they may fall
down and cause body injury. Follow
the procedures described below to
attach or remove them.
2-1-1 Usable Batteries
Batteries that can be used with this
unit are as follows. For each type of
battery, a special battery adaptor and
battery charger is required.
Notes about battery usage
• Before using the batteries, be sure to
charge them fully with the special
battery charger. Refer to the
operating instructions of your battery
charger for more information about
how to charge the batteries.
• Batteries may not be completely
charged if you charge them
immediately after use when they are
still warm. You should wait until the
batteries cool before charging them.
2-1-2 Using the BP-
L60(A)/L90(A) Battery
Pack
This unit can be operated for about 80
minutes at normal temperature on
fully charged BP-L90 Battery Pack.
To charge the battery pack
Before use, charge the battery pack
with the BC-L100/L100CE Battery
Charger. It takes about 2.5 hours to
charge the BP-L60(A) and about 3.5
hours to charge the BP-L90(A).
For more information about how to
charge the battery pack, refer to the
manual for the BC-L100/L100CE.
To attach the battery pack
Attach the BP-L60(A)/L90(A) as
shown in the figure on next page.
Before attaching, remove the cover of
the battery connector.
Remove the cover in the same way that
you remove the battery pack. For
details see the next section “To
remove the battery pack”.
Battery
Battery
Adaptor
Battery
Charger
BP-90(A)
(mounted on
this unit)
DC-L90 BC-210/210CE/
410/410CE
BP-90(A)
(connected
to DC IN
connector)
DC-210 BC-210/210CE/
410/410CE
BP-L60(A)/
L90(A)
Not
needed
BC-L100/
L100CE/L50
To Next Page
Loading...
Need help?
General
