Special Editing
3-22 Editing
Chapter 3 Editing
1 Press the RECORDER button,
lighting the indicator.
2 Use the jog or shuttle dial to find
the point where the edit will start
(the recorder IN point), and stop
the tape slightly in advance of this
point.
Note
There will be some screen
breakup at this point if the edit
starts with the recorder unit in
stop mode.
3 Select the edit mode.
4 Press the PLAY button.
Recorder unit playback starts.
Note
About 2 seconds are required for
the picture to stabilize. You
should begin playback at a point
on the tape more than 2 seconds in
advance of the section you will
use in the edit.
5 Press the EDIT button together
with the PLAY button at the point
where you want to start the edit
(the recorder IN point).
The edit starts.
6 Press the PLAY button at the
point where you want to end the
edit (the recorder OUT point).
The edit ends but player unit’s
playback continues.
7 Press the STOP button to stop
recorder unit’s playback.
To Next Page
Loading...
Need help?
General
