331
• It is not possible to add temporary attributes to a
master snapshot.
5
Press the [ENTER] button.
The specified snapshot is recalled.
When a master snapshot is recalled, the region
selection buttons are lit according to the saved region
information.
To cancel a snapshot recall operation
To cancel the snapshot recall, press the [UNDO] button.
It is not possible to cancel recalling of a master snapshot.
Creating and saving a master snapshot
Use the same procedure for creating and saving a master
timeline.
For master snapshot operations, use the [SNAPSHOT]
button instead of the [EFF] button.
For details, see “Creating and Saving a Master Timeline
(Numeric Keypad Control Block)” (page 322).
Snapshot Operations
(Flexi Pad Control Block)
In the Flexi Pad control block on each M/E bank and PGM/
PST banks, you can only carry out operations on snapshots
for that bank.
Flexi Pad control block
Banks and Registers
To allow operations on the 250 registers, the Flexi Pad
control block treats the registers in groups. These groups
are called “banks.” There are 26 banks, numbered 0 to 25,
and the following registers correspond to each bank.
Note
Bank
number
Register
number
Bank
number
Register
number
Bank 0 1 to 9 Bank 13 130 to 139
Bank 1 10 to 19 Bank 14 140 to 149
Bank 2 20 to 29 Bank 15 150 to 159
Bank 3 30 to 39 Bank 16 160 to 169
Bank 4 40 to 49 Bank 17 170 to 179
Bank 5 50 to 59 Bank 18 180 to 189
Bank 6 60 to 69 Bank 19 190 to 199
Bank 7 70 to 79 Bank 20 200 to 209
DEL button
UNDO button
Bank selection buttons
Memory recall section
SNAPSHOT button
To Next Page
Loading...
Need help?
General
