When [Log Shooting] is set to [Cine EI Quick] or [Cine EI]:
The EI value, latitude, Base ISO ([L] for low sensitivity and [H] for high sensitivity) are displayed.
Example: 800EI/6.0E/L
The second numerical value of the setting indicates how many steps of brightness information are assigned for bright
areas (brightness higher than 18% gray). Areas brighter than these are overexposed.
Example: In “800EI/6.0E,” 6.0 steps are assigned on the bright side.
Hint
To output RAW movies to another device connected via HDMI, set [Log Shooting] to an item other than [Off]. The [Color Gamut]
setting is also applied to RAW movies output via HDMI.
Note
[Embed LUT File] is locked to [Off] when using SD cards or SDHC cards.
When [Log Shooting] is set to an item other than [Off], this may cause an error in the white balance custom setup. In such a case,
temporarily set [Log Shooting] to [Off], perform the custom setup, and then reset [Log Shooting] to the desired setting.
Related Topic
Picture Profile (still image/movie)
Log shooting
5-043-414-12(1) Copyright 2022 Sony Corporation
To Next Page
Loading...
Need help?
General
