Selecting the Default Settings
13
Selecting the Default
Settings
When you turn on the unit for the first time after
purchasing it, select the area where you intend to use this
unit from among the options.
The default setting values for each area
1
Press the 1 (standby) switch.
The power is turned on and the SELECT SETTING
screen appears.
2
Press the M or m button to select the area where you
intend to use the unit and press the , or ENTER
button.
If you select either 1, 3 or 5
The confirmation screen is displayed. Confirm the
selected area. When the setting is wrong, press the
< button to return to the previous screen.
If you select either 2 or 4
One of the following screens appears. Press the M
or m button to narrow the area further and then
press the , or ENTER button.
The confirmation screen is displayed. Confirm the
selected area. When the setting is wrong, press the
< button to return to the previous screen.
3
3
4
5
3
1
2
COLOR
TEMP
COMPONENT
LEVEL
NTSC
SETUP
1NORTH AMERICA LOW BETA7.5 7.5
2LATIN AMERICA
PAL&PAL-N
AREA
ARGENTINA LOW SMPTE 0
PARAGUAY LOW SMPTE 0
URUGUAY LOW SMPTE 0
NTSC&PAL-M
AREA
OTHER AREA LOW BETA7.5 7.5
3AFRICA AUSTRALASIA
EUROPE MIDDLE-EAST
LOW SMPTE 0
4ASIA EXCEPT
JAPAN
NTSC AREA LOW BETA7.5 7.5
PAL AREA LOW SMPTE 0
5JAPAN HIGH SMPTE 0
RESET
MENU
VOLUME
KEY
INHIBIT
ENTER
1
1
2~3 1
S E L E C T S E T T I N G
N O R T H _ A M E R I C A
L A T I N A M E R I C A
A F R I C A A U S T R A L A S I A E
A S I A E X C E P T J A P A N
J A P A N
1North America
2Latin America
3Africa, Australia/New
Zealand, Europe,
Middle East, Russia
4Asia Except Japan
5Japan
S E L E C T T H I S A R E A ?
[ E N T E R ] Y E S
[ M E N U ] NO
N O R T H A M E R I C A
To Next Page
Loading...
Need help?
General
