Help Guide
Wireless Noise Canceling Stereo Headset
MDR-1000X
Sound skips frequently during playback.
Set the headset to the “Priority on stable connection” mode. For details, refer to “Switching the sound quality mode.”
Remove any obstacles between the antenna of the BLUETOOTH device to be connected and the built-in antenna of the
headset. The antenna of the headset is built into the part shown in the dotted line below.
A: Location of the built-in antenna
BLUETOOTH communications may be disabled, or noise or audio dropout may occur under the following conditions.
There is a human body between the headset and the BLUETOOTH device. This situation may be improved by placing the
BLUETOOTH device facing the antenna of the headset.
There is an obstacle, such as metal or wall, between the headset and the BLUETOOTH device.
A device using 2.4 GHz frequency, such as a Wi-Fi device, cordless telephone, or microwave oven, is in use near this
headset.
The situation may be improved by changing the wireless playback quality settings or fixing the wireless playback mode to SBC
on the transmitting device. For details, refer to the operating instructions supplied with the transmitting device.
4-595-263-11(1) Copyright 2016 Sony Corporation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
