Connecting the last-connected audio
device from this unit
1 Be sure that both this unit and the audio device
are switched to Bluetooth signal on.
2 Press
(SOURCE)
repeatedly until
"BT
AUDIO" appears.
3 Press
®.
"~~"
flashes while the connection is being
made. And then
"~~"
stays lit when the
connection is made.
Handsfree
talking
Receiving calls
When receiving a call, a ring tone is output from
your car speakers. Check that the unit and
cellular phone are connected beforehand.
1
Press'-
(handsfree) when a call is
received with a ring tone.
The phone call starts.
To
end a call
Press
'-
(handsfree) again, or (
OFF).
To
reject an incoming call, press and hold
'-
(handsfree) for 2 seconds.
Mic Gain adjustment
You can switch between two volume levels
("LOW" or "HI") to set a suitable level for the
other party during a call.
1 Press
® during a call.
The item changes as follows:
MIC-LOW
+-+
MIC-HI
Note
The microphone
of
this unit is located on the rear
of
the front panel (page 9). Do not cover the microphone
with tape, etc.
Making calls
In the case
of
making calls from this unit, redial
is used.
1 Press
(SOURCE)
repeatedly until "BT
PHONE" appears.
2 Press and hold
'-
(handsfree) for 3
seconds or more.
The phone call starts.
To
end a call
Press
'-
(handsfree) again, or (
OFF).
To
call another phone, use your cellular phone,
and then transfer the call.
For call transfer details, check the following.
Call transfer
In order to activate/deactivate the appropriate
device (this unit/cellular phone), check the
following.
1 Press and hold
'-
(handsfree) or use
your cellular phone.
For details on cellular phone operation, refer to
your cellular phone manual.
Note
Depending on the cellular phone, handsfree
connection may be cut
off
when call transfer is
attempted.
Voice Dial Activation
You can activate voice dialing with a cellular
phone connected to this unit by saying the voice
tag stored on the cellular phone, then make a call.
1 Press
(SOURCE)
repeatedly until "BT
PHONE" appears.
2
Press'-
(handsfree). •
The cellular phone enters voice dialing mode.
3 Say the voice tag stored
on
the cellular
phone.
Your voice is recognized, and the call is
made.
Notes
o Check that unit
and
cellularphone are connected
beforehand.
o Store a voice tag on your cellular phone beforehand.
o
If
you activate voice dialing with a cellular phone
connected to this unit, this function may not always
work in some cases.
o Noises such as the engine running may interfere
with sound recognition. In orderto improve
recognition, operate underconditions where noise is
minimized.
o Voice dialing may not work in some situations,
depending on the effectiveness
of
the cellular
phone's recognition function. For details, see the
support site (page 23).
Tips
o Speak in the same way as you did when you stored
the voice tag.
o Store a voice tag while seated in the
car,
via this unit
with
"aT
PHONE" source selected.
13
To Next Page
Loading...
