• Halogenated flame retardants are not used
in
the
certain printed wiring boards.
• Halogenated flame retardants are not used
in
cabinets.
• Packaging cushions are made from paper.
Troubleshooting
The
following
checklist
will
help
you
remedy
problems
you
may
encounter
with
your
unit.
Before
going
through
the
checklist
below,
check
the
connection
and
operating
procedures.
If
the
problem
is
not
solved,
visit
the
following
Support
site.
Support site
If
you
have
any
questions
or
for
the
latest
support
information
on
this
product,
visit
the
web
site
below:
http://esupport.sony.com
http://www.sony.comixplod
No power Is being supplied to the unit.
o Check the connection.
If
everything is in order, check
the fuse.
o
If
the unit is turned
off
and the display disappears, it
cannot be operated with the remote commander.
-+
Tum
on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
No sound.
o The volume is too low.
o The ATT function is activated,
or
the Telephone ATT
function (when the interface cable
of
a car telephone
is
connected to the ATT lead) is activated.
o The position
of
the fader control "FAD" is not set for
a 2-speaker system.
o The
CD
changer is incompatible with the disc format
(MP3fWMA).
-+
Play back with a Sony MP3 compatible CD
changer, or this unit.
o The Bluetooth audio device is in pause.
-+
Cancel pause.
No beep sound.
o The beep sound
is
canceled (page 15).
o
An
optional poweramplifier is connected and you are
not using the built-in amplifier.
The contents
of
the memory have been erased.
o The RESET button has been pressed.
-+
Store again into the memory.
o The power supply lead
or
battery has been
disconnected.
o The power supply lead is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position
of
the ignition
is switched.
The leads are not matched correctly with the car's
accessory power connector.
During playback
or
reception, demonstration
mode starts.
If
no operation is performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
-+
Set "DEMO-OFF" (page 16).
The display disappears from/does not appear
in the display window.
o The dimmer is set "DIM-ON" (page 16).
o The display disappears
if
you press and hold
(OFF).
-+
Press and hold
(OFF)
on the unit until the
display appears.
o The connectors are dirty (page 21).
The Auto Off function does not operate.
The unit is turned on. The Auto
Off
function activates
after turning
off
the unit.
-+
Tum
off
the unit.
Card remote commander operation Is not
possible.
Make sure the insulation film has been removed
(page 6).
The disc cannot be loaded.
o Another disc is already loaded.
o The disc has been forcibly inserted upside down or in
the wrong way.
The disc does not play back.
o Defective or dirty disc.
o
The
CD-Rs/CD-RWs are not for audio use (page 19).
MP3IWMA files cannot be played back.
The disc
is
incompatible with the MP3fWMA format
and version (page 19).
MP3IWMA files take longer to play back than
others.
The following discs take a longer time to start
playback.
- a disc recorded with a complicated tree structure.
- a disc recorded in Multi Session.
- a disc to which data can be added.
The display items do not scroll.
o For discs with very many characters, those may not
scroll.
o "A.SCRL" is set to "OFF".
-+
Set "A.SCRL-ON" (page 16).
-+
Press and hold
(DSPL)
(SCRL).
The sound skips.
o Installation is not correct.
-+
Install the unit at an angle
of
less than 45° in a
sturdy part
of
the car.
o Defective or dirty disc.
continue
to
next
page
--
•
23
To Next Page
Loading...
Need help?
General
Weight and Dimensions
