Sony MKS-8080 User Manual

15
Preparations
Making the Settings With Buttons
(Setup Function)
With the S-BUS system, the necessary items are normally
set at the terminal connected to the primary station.
However, the following items may be set on this unit
alone.
Turn the power on while holding down two or more source
select buttons, or press the buttons during restarting
(button-illumination test) after software reset.
Note
An operation by turning the power on while holding down
some buttons and an operation by pressing the buttons
during restarting triggered by pressing the X-HOLD/XPT
HOLD button and LOCK (CHOP) or KEY button
(software reset) lead to the same result.
You may perform setup by either method.
Numbers of the source-select buttons
Initialization
To initialize the settings
While holding down buttons [1] and [2], turn the power on.
The unit is set to the following factory-set conditions:
• Type + Number selection system
• In AUX mode: Source select buttons [1] through [32]
correspond to sources 1 through 32, reentry buttons
correspond to sources 121 through 124, and destination
select buttons [1] through [16] correspond to destinations
1 to 16.
• In RTR mode: Source select buttons [1] through [32]
correspond to sources 1 through 32, reentry buttons
correspond to sources 121 through 124, and destination
select buttons [1] through [16] correspond to destinations
17 to 32.
• Single-Use (Standalone) mode
• Single-Level mode
Selecting the operation modes
To enter Station Number Setting mode
While holding down buttons [1], [2], [3] and [4], turn the
power on.
The station number can be set using buttons [1] through
[8].
To set the level select buttons to Multi-Level
mode
While holding down buttons [1] and [6], turn the power on.
To set the level-select buttons to Single-Level
mode
While holding down buttons [1] and [7], turn the power on.
To change the numbers of the source select
buttons (MKS-8082 only)
The numbers of the source select buttons on the MKS-
8082 can be changed; i.e. source select buttons [1] through
[16] will be source select buttons [17] through [32], and
vice versa.
While holding down buttons [4] and [5], turn the power on.
To return to the factory-set button numbers, perform the
same operation.
List of setup operations
Note
Setup with the buttons should be performed with the
factory-setting button number.
12345678910111213141516
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
12345678910111213141516 2726 28 29 30 31 32
MKS-8080
MKS-8082
Settings Buttons to be pressed
To initialize the settings [1], [2]
To enter Station Number
Setting mode
[1], [2], [3], [4]
To set the level select buttons
to Multi-Level mode
[1], [6]
To set the level select buttons
to Single-Level mode
[1], [7]
To change the button number
(MKS-8082)
[4], [5]

Sony MKS-8080 Specifications

General

Brand	Sony
Model	MKS-8080
Category	Remote Control
Language	English