Sony SNC-VB600B User Manual

Administrating the Camera
Configuring the Network — Network Menu
38
MTU
Type the IP-MTU value for the Ethernet port.
To obtain DNS server address
automatically
Select Obtain DNS server address automatically.
The Primary DNS server and Secondary DNS
server are assigned automatically.
Note
To obtain a DNS server address automatically, first
enable Obtain an IP address automatically
(DHCP) in the IPv4 setting, or Obtain IP address
automatically in the IPv6 setting.
Ask the network administrator whether a DNS
server address can be obtained automatically.
To specify the DNS server address
manually
Deselect Obtain DNS server address
automatically. Type the address in the Primary
DNS server and Secondary DNS server boxes.
Primary DNS server: Type the IP address of the
primary DNS server.
Secondary DNS server: Type the IP address of the
secondary DNS server, if necessary.
OK/Cancel
See “Buttons common to every menu” on page 22.
Wi-Fi Tab
Display sample: SNC-CX600W
Supported models: SNC-CX600W
Use this tab to set the connection of the Wi-Fi network.
Notes
• A wired network and a Wi-Fi network cannot be used
at the same time.
• The IP address of a Wi-Fi network will be assigned
only when a wired network is not connected.
Wi-Fi network connection check
Displays the current connection status of a Wi-Fi
network.
If the camera is connected to a Wi-Fi router, the display
will be highlighted.
SSID
Displays SSID of the Wi-Fi router that can be connected
to.

Sony SNC-VB600B Specifications

General

Brand	Sony
Model	SNC-VB600B
Category	Security Camera
Language	English