adjusted. Be considerate of your neighbors and any children who are present.
If the muting function has been activated before you perform Auto Calibration, the muting
function will shut off automatically.
It may not be possible to take the correct measurements or to perform Auto Calibration at
all if special speakers such as dipole speakers are used.
Connecting the optimizer microphone
Optimizer microphone (supplied)
1. Connect the supplied optimizer microphone to the AUTO CAL MIC jack.
2. Set up the optimizer microphone.
Place the optimizer microphone where you will sit and set it at the same height as your
ears.
Confirming active subwoofer setup
When a subwoofer is connected, turn on the subwoofer and turn up the volume prior to
activating the subwoofer. Turn the LEVEL to just before the mid-point.
If you connect a subwoofer with a crossover frequency function, set the value to
maximum.
If you connect a subwoofer with an auto standby function, set it to off (deactivated).
To Next Page
Loading...
Need help?
General
