Note
Depending on the characteristics of the subwoofer you are using, the setup distance
value may be different from the actual position.
Selecting the front speakers
You can select the front speakers you want to operate.
Be sure to use the buttons on the receiver to perform this operation.
1. Press SPEAKERS on the receiver repeatedly to select the front speaker system you
want to operate.
The indicators on the display panel shows which set of terminals are selected.
SP A :
Speakers connected to the SPEAKERS FRONT A terminals.
SP B (*1):
Speakers connected to the SPEAKERS SURROUND BACK/FRONT HIGH/FRONT B/BI-
AMP/ZONE 2 terminals.
SP AB (*1):
Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND
BACK/FRONT HIGH/FRONT B/BI-AMP/ZONE 2 terminals (parallel connection).
(None):
[SPEAKERS OFF] appears on the display panel. No audio signals are output from any
speaker terminals, or the PRE OUT (*2) jacks.
*1
To select [SP B] or [SP AB], set the assignment for the SPEAKERS SURROUND BACK/FRONT
HIGH/FRONT B/BI-AMP/ZONE 2 terminals to [Front B] by using [SB Speaker Assign] in the Speaker
Setup menu.
*2
The PRE OUT jacks are only for STR-ZA3000ES.
To Next Page
Loading...
Need help?
General
