Sony STR-ZA1000ES - Page 73

3. Select the speaker pattern you want.
[66] Adjusting Settings Speaker Setup
Setting the assignment for the speaker terminals (SB
Speaker Assign)
You can set the assignment for the SPEAKERS SURROUND BACK/FRONT HIGH/FRONT
B/BI-AMP/ZONE 2 terminals.
1. Select [Setup] - [Speaker Setup] from the home menu.
2. Select [SB Speaker Assign].
3. Set [SB Speaker Assign] to any of the following settings.
Zone2
When using the zone 2 connection.
Bi-Amp
When using the bi-amplifier connection.
Front B
When using the front B speaker connection.
Off
When none of the connections above are used.
Note
When you change the connection from a bi-amplifier or speakers front B to surround back
or front high speakers connection, set the [SB Speaker Assign] to [Off], then set up the
speakers again.
You can only set the assignment for the SPEAKERS SURROUND BACK/FRONT
HIGH/FRONT B/BI-AMP/ZONE 2 terminals if the speaker pattern is set to 2/0, 2/0.1, 3/0,
3/0.1, 2/2, 2/2.1, 3/2, or 3/2.1.
[67] Adjusting Settings
Speaker Setup
Adjusting the speaker size (Size)