Help Guide
Digital Camera
ZV-1M2
Cont. Bracket
Shoots multiple images while automatically shifting the exposure from base to darker and then to lighter. You can select
an image that suits your purpose after recording.
Menu item details
For example, the camera shoots a total of three images continuously with an exposure value shifted by plus or minus 0.3
EV when [Cont. Bracket: 0.3EV 3 Image] is selected.
Hint
The last shot is shown on the auto review.
Note
When [ISO AUTO] is selected in [Manual Exposure] mode, the exposure is changed by adjusting the ISO value. If a setting other
than [ISO AUTO] is selected, the exposure is changed by adjusting the shutter speed.
When the exposure is compensated, the exposure is shifted based on the compensated value.
Bracket shooting is unavailable in the following shooting modes:
[Intelligent Auto]
[Scene Selection]
When [
Picture Profile] is set to other than [Off]
When the flash is used, the product performs flash bracket shooting, which shifts the amount of flash light even if [Cont. Bracket]
is selected. Press the shutter button for each image.
Related Topic
Bracket Settings
Indicator during bracket shooting
Press / (Drive Mode) of the control wheel → [Cont. Bracket].
You can also set the drive mode by selecting MENU →
(Shooting) → [Drive Mode] → [Drive Mode].
1
Select the desired mode using the right/left side of the control wheel.
2
Adjust the focus and shoot the image.
Keep pressing and holding the shutter button until bracket shooting is finished.
3
To Next Page
Loading...
Need help?
General
