Help Guide
Digital Camera
ZV-1M2
Connecting the camera to a computer
Note
Do not turn on/off or restart the computer, or wake the computer from sleep mode when a USB connection has been established
between the computer and the camera. Doing so may cause a malfunction. Before turning on/off or restarting the computer, or
waking the computer from sleep mode, disconnect the camera from the computer.
Related Topic
USB Connection Mode
USB LUN Setting
5-049-603-11(1) Copyright 2023 Sony Corporation
Insert a sufficiently charged battery pack into the camera.
1
Turn on the camera and the computer.
2
(Setup) → [USB] → Set [USB Connection Mode] to [MassStorage(MSC)].
3
Connect the USB Type-C terminal on the camera to the computer with a commercially available USB cable.
When you connect the camera to the computer for the first time, the procedure for recognizing the camera may
start automatically on the computer. Wait until the procedure is finished.
If you connect the camera to your computer using the USB cable when [USB Power Supply] is set to [On],
power is supplied from your computer. (Default setting: [On])
Use a cable that complies with the USB standard.
4
To Next Page
Loading...
Need help?
General
