WORKSHOP MANUAL
4 - MAINTENANCE
EDITION
PAGE
23 /37
The replacement of the control belt can be performed without having to remove the cutting
deck from the machine.
• Disconnect the belt from the PTO by following the relative procedure in reverse order.
from 3 to 1.
• Replace the belt following the relative procedure.
from 1 to 4.
The replacement of the blade connecting belt can be performed both with the cutting
deck connected to the machine and also to the bench; this latter solution is however preferable as
it allows better accessibility and ease of operation.
The following operations are easier to perform if the cutting deck is in the minimum height position
«1».
If the plate was removed from the machine set at a different
height, it is possible to intervene by connecting the electric
control connector to an external 12 Volt battery, until the de-
sired working condition is obtained.
• Remove the cutting deck from the machine
.
• Remove the canvas guard
from 1 to 3 .
• Remove the intermediate guard
from 1 to 5.
1. Undo the screw (1) and remove the protection (2) by lifting it from the rear section.
2. Undo the two screws (3), remove the belt guide (4) and remove the belt (5).
To Next Page
Loading...
Need help?
General
