WORKSHOP MANUAL
4 - MAINTENANCE
EDITION
PAGE
33 /37
1. Remove the crown fastener (1) at the lower
end of the handle (3) pin (2) and extract the
pin.
2. Release the barrel end (4) of the cable (5) from
the handle (3).
3. Disconnect the adjuster (6) from the support.
4. Disconnect the spring (7) from the cam (8).
5. Pull the cable (5) to remove it from its housing
inside the frame tubes.
6. Insert the new cable inserting it into the frame
tube from the front and connect the spring (7).
8. Restore the connection with the handle (3)
and adjust the adjuster (6) to ensure correct
functioning and engagement in the lever seat
(9).
- The correct functionality
of the system is of fundamental importance
to guarantee the operator's safety when ac-
cessing the lower part of the cutting deck.
The supports of the front cutting deck wheel swivel in relation to the frame; the fork support of each
wheel is equipped with a pin whose movement inside the hub is facilitated by the presence of two
bushings.
To Next Page
Loading...
Need help?
General
