EN - 10
4.
and rotate the pin in order to bend
so that it cannot slide out, causing
Check that the spring works
correctly and keep the side discharge
chute securely lowered. Make sure
that the pin is fitted properly to prevent
it from falling out accidentally.
5. CONTROLS
5.1 BRAKE PEDAL
)
5.2 FORWARD GEAR PEDAL
1. Forward drive gear. Increasing
the pressure on the pedal
2. Neutral position. The pedal
NOTE The “Neutral” condition is
indicated by the lamp (g. 16.F).
NOTE If the operator presses the
pedal while the parking brake (g.
13.D) is on, the engine stops.
5.3 REVERSE GEAR PEDAL
, 14.C
1. Reverse gear. Increasing
the pressure on the pedal
.
Reverse must only
be engaged when the
machine has stopped.
2. Neutral position. The pedal
NOTE The “Neutral” condition is
indicated by the lamp (g. 16.F).
NOTE If the operator presses the
pedal while the parking brake (g.
15.D) is on, the engine stops.
5.4 HYDROSTATIC DRIVE
RELEASE COMMAND
indicated on the label (
1. for all uses,
2. this
the
IMPORTANT To avoid damaging the drive
unit, perform this operation only when the
engine is stopped and the pedals (g. 13.B,
13.C, 14.B, 14.C) are in the neutral position.
• 4WD model only
5.5 KEY IGNITION SWITCH
1. Stop position.
2. On position. All functions are active.
3. Start position.
To Next Page
Loading...
Need help?
General
