Stihl RE 80 User Manual

0458-001-9621-A
57
English 8 Connecting to a water source
► Turn on the water tap fully and flush the water hose with
water.
Sand and dirt will be flushed out of the water hose. The
water hose will be vented.
► Turn off tap.
► Push the coupling (1) onto the connector (2).
The coupling (1) engages with an audible click.
► Turn tap fully on.
► If the spray lance is attached to the spray gun: Remove
the spray lance.
► Squeeze the spray gun trigger until an even water jet is
delivered from the spray gun.
► Release the spray gun trigger.
► Lock the spray gun trigger.
► Attach the spray lance.
► Attach the nozzle.
Removing the water hose
► Turn off tap.
► To unlock the coupling: Pull the ring (1) or twist and hold it.
► Pull the coupling off the connector (2).
8.2 Connecting the high-pressure washer to
another water supply
The high-pressure washer can draw in water from water
butts, storage tanks and flowing or still rivers and lakes.
So that the water can be drawn in, the height difference
between the high-pressure washer and the water source
must not exceed the max. suction lift (a), @ 19.2.
The appropriate STIHL suction set must be used. The
suction set includes a water hose with a special coupling.
Depending on the market, the appropriate STIHL suction set
may be included with the high-pressure washer.
1
2
0000098890_001
1
2
0000098891_001
a
0000098892_001

Stihl RE 80 Specifications

General

Brand	Stihl
Model	RE 80
Category	Floor Machine
Language	English