Stihl RE 80 User Manual

0458-001-9621-A
61
English 12 After Finishing Work
► Adjust the fan-jet nozzle so that the surface to be cleaned
is not damaged.
► Move the spray attachment evenly along the surface to be
cleaned.
► Move forward slowly in a controlled manner.
11.4 Working with Detergent
Detergents can increase the cleaning effect of the water.
The supplied STIHL spraying set must be used.
► Dose and use detergent as described in the instructions
for use of the detergent.
► Fill the bottle (1) with maximum 500 ml of the detergent.
► Screw the spray nozzle (2) onto the bottle (1) and tighten
firmly by hand.
► If a nozzle is attached to the spray lance (3): Remove the
nozzle.
► Attach the spray set (4) to the spray lance (3).
► Soak extremely dirty surfaces with water before cleaning
them.
► Press the spray gun lever and spray the detergent onto
the surface to be cleaned.
► Apply the detergent starting at the bottom and working up
and do not allow to dry.
► Remove the spraying set.
► Attach the nozzle.
► Clean the surface.
12.1 When Work is Finished
► Switch off the high-pressure washer and pull the mains
plug out of the socket.
► If the high-pressure washer is connected to the water
supply: Turn off water supply.
► Press the spray gun trigger.
The water pressure is reduced.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the water
source.
► Remove the water hose.
0000-GXX-5094-A0
2
1
0000097580_001
12 After Finishing Work
3
4
0000097581_002

Stihl RE 80 Specifications

General

Brand	Stihl
Model	RE 80
Category	Floor Machine
Language	English