0478 131 8365 C - EN
26
9.4 Installation material
If the perimeter wire is not routed by the
specialist dealer, additional installation
material not included in the standard
equipment will be required to be able to
operate the robotic mower. (Ö 18.)
The installation kits contain perimeter wire
on a reel (1) as well as fixing pins (2) and
wire connectors (3). The standard
equipment in the installation kits may
include additional parts not required for the
installation.
9.5 Adjusting the cutting height
Lowest cutting height:
Level S1 (20 mm)
Highest cutting height:
Level 8 (60 mm)
– Open the flap. (Ö 15.2)
Turn the rotary knob (1). The marking (2)
indicates the set cutting height.
9.6 Notes on initial installation
An installation assistant is
available for installation of the
robotic mower. This program
guides you through the entire
initial installation process:
● Setting the language, date and time
● Installing the docking station
● Routing the perimeter wire
● Connecting the perimeter wire
● Linking the robotic mower and docking
station
● Checking installation
● Programming the robotic mower
● Completing initial installation
The installation assistant must be worked
through in its entirety. Only then is the
robotic mower ready for operation.
Preparatory measures:
● Mow the lawn using a conventional
lawn mower prior to initial installation
(ideal grass height max. 6 cm).
● In the case of a hard and dry surface,
water the mowing area lightly in order to
make it easier to drive in the fixing pins.
● The robotic mower must be activated by
a STIHL specialist dealer and assigned
to the owner's e-mail address. (Ö 10.)
Set the cutting height to at least
level 4 in the first weeks (until the
grass has grown over the perimeter
wire) to guarantee reliable
operation.
Levels S1, S2 and S3 are special
heights for very level lawns (ground
unevenness < +/- 1 cm).
The rotary knob can be removed
upwards from the adjustment
element. This design serves a
safety function (it ensures that the
machine cannot be lifted and
carried by the rotary knob) and to
prevent the cutting height from
being modified by unauthorised
persons.
The installation assistant is re-
activated following a reset (reset to
factory defaults). (Ö 11.17)
When navigating through the
menus, follow the instructions in the
"Operating instructions" section.
(Ö 11.1)
You can select options, menu items
and buttons using the control pad.
You can open submenus and
confirm selections using the
OK button.
Use the Back button to
leave the active menu or
jump one step back in the
installation assistant.
If errors or faults occur during the
initial installation, a corresponding
message appears on the display.
(Ö 23.)
To Next Page
Loading...
Need help?
General
