EN
51
0478 131 8365 C - EN
– Date and time
– Start time:
Start of the next planned mowing
operation
– Total number of completed mowing
operations
– Mowing hours:
Duration of all completed mowing
operations in hours
– Distance:
Total distance covered in metres
– Ser.-No.:
Serial number of the robotic mower.
This can also be found on the
identification plate (see Machine
overview). (Ö 3.1)
–Battery:
Serial number of the battery
– Software:
Installed machine software
4. Lawn status:
Information on the lawn
– Mowing area in square metres:
This value is entered during initial
installation or new installation. (Ö 9.13)
– Round time:
Duration of one circuit around the
mowing area in minutes and seconds
– Starting points 1 – 4:
Distance of the relevant starting point
from the docking station in metres,
measured in a clockwise direction.
(Ö 11.14)
– Circumference:
Circumference of the mowing area in
metres
– Edge mowing:
Frequency of edge mowing per week
(Ö 11.13)
5. Radio module status:
Information on the radio module
– Satellites:
Number of satellites within range
– Position:
Current position of the robotic mower;
available if the satellite connection is
strong enough
– Signal strength:
Signal strength of the mobile radio
connection; the more plus characters
shown (max. "++++"), the better the
connection.
–Network:
Network ID, comprising country code
(MCC) and provider code (MNC)
– Mobile phone number:
Mobile phone number of the owner; is
entered in the app. (Ö 10.)
–IMEI:
Hardware number of the radio module
–IMSI:
International mobile subscriber identity
–SW:
Software version of the radio module
– Ser.-No.:
Serial number of the radio module
– Modem SN:
Serial number of the modem
Check the installation of the perimeter wire
before it is finally secured in place. (Ö 9.)
Adjustments to the wire routing are
generally necessary in the vicinity of
corridors, confined areas or no-go areas.
Deviations can occur
– if the technical limits of the robotic
mower are reached, for example with
very long corridors or when routing the
perimeter wire in the vicinity of metal
objects or above metal under the lawn
(e.g. water pipes and power supply
lines),
– if the mowing area is structurally altered
for using the robotic mower.
12. Perimeter wire
Before routing the
perimeter wire,
particularly prior to initial
installation, read the
entire section and plan the wire
routing in detail.
Perform initial installation using the
installation assistant. (Ö 9.)
Should you require support, your
STIHL specialist dealer will be
pleased to assist you with
preparation of the mowing area and
installation of the perimeter wire.
To Next Page
Loading...
Need help?
General
