4-10 FUEL SYSTEM
CLEANING AND INSPECTION
Clean thoroughly with cleaning solvent and compressed air
before inspection.
CARBURETOR BODY AND FLOAT CHAMBER
Inspect the carburetor body and the float chamber. If crack or
other damage is found, replace the body and/or the chamber.
Clean the carburetor body and the float chamber in order to
remove obstructions.
JET/NOZZLE
Inspect the jets and the nozzle. If crack or other damage is
found, replace the jet and/or the nozzle.
Clean the jets and the nozzle in order to remove obstructions.
NEEDLE VALVE
Inspect the needle valve.
If broken tip or wear is found, replace the valve.
Wear safety glasses when using compressed air to
expel solvent, carburetor cleaner etc.
Do not place any rubber, plastic and non-metallic
parts in cleaning solvent, as severe damage or deteri-
oration will result.
Do not use a wire or a small drill bit in order to clean
the orifices and jets of the carburetor.
To Next Page
Loading...
Need help?
General
