PERIODIC MAINTENANCE 2-19
LOW PRESSURE FUEL FILTER
If leakage, cracks or other damage is found, replace the fuel fil-
ter.
NOTE:
When water is present in the fuel supply, the red indicator float
surrounding the filter element rises.
Whenever the red float is up, remove filter cap and drain the
water.
Inspect and Cleaning
%
1. Turn the engine “off”.
2. Remove the two (2) bolts securing low pressure fuel filter to
filter bracket and remove fuel filter.
3. Remove the ring nut
2.
4. Separate the filter cap
3 from filter body
1, then remove
large O-ring
4, filter element
5 and small O-ring
6.
5. Inspect filter element and O-rings for damage.
Replace if damaged.
6. Wash the filter element with cleaning solvent.
7. Assemble the small O-ring
6 and filter element
5 to filter
body
1.
8. Install large O-ring
4 and filter cap
3, then thread the ring
nut
2 into position.
9. Install low pressure fuel filter and tighten bolts securely.
10. Restart the engine and check that there are no leaks around
the fuel filter.
HIGH PRESSURE FUEL FILTER
SUZUKI recommends that replacing the high pressure fuel filter
every 1 000 operating hours.
• Inspect before every use.
• Inspect every 50 hours (3 months).
• Replace every 400 hours or 2 years.
• Stop the motor before cleaning the fuel filter.
• Do not smoke and keep open flames and sparks
away while working near any part of the fuel system.
Replace every 1 000 hours.
1. Fuel filter
1
Red float
Spring
1
1. High pressure fuel filter
To Next Page
Loading...
Need help?
General
