EasyManuals Logo
Home>Suzuki>Outboard Motor>DF200

Suzuki DF200 Service Manual

Suzuki DF200
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
ENGINE CONTROL SYSTEM 3-41
CONDITION FOR SELF-DIAGNOSTIC SYSTEM OPERATION
FAILED ITEM CONDITION
MAP sensor 1 No signal (With engine running)
Receiving an out of range “37 – 860 mmHg (1.46 – 33.86 inHg)
(0.50 – 4.84 V)” signal (With engine running)
IAC valve/By-pass air screw
adjustment
IAC valve operates at 80% duty or higher when ECM receives fully
closed position signal from throttle position sensor.
[NOTE 1]
Cylinder temp. sensor No signal
Receiving an out of range “– 46 to +170 °C (– 114.8 – +338 °F)
(0.10 – 4.6 V)” signal
IAT sensor No signal
Receiving an out of range “– 46 to +169 °C (– 114.8 – +336.2 °F)
(0.10 – 4.6 V)” signal
CKP sensor During one crankshaft rotation, 34 signals are not input to ECM.
CMP sensor During two crankshaft rotation, 4 signals are not input to the ECM.
Air intake system During the ECM’s receiving input of the complete close signal from the
throttle position sensor, the engine operates at an abnormally high
speed. (Criterion: 2 500 r/min MIN)
MAP sensor 2
(Pressure detect passage)
Receiving unchanging signal regardless engine speed change.
[NOTE 2]
Rectifier & Regulator.
(Over-charging)
Receiving 16 volts or higher signal
Exhaust manifold temp. sensor
(PORT or STBD)
No signal
Receiving an out of range “– 46 to +170 °C (– 114.8 – +338 °F)
(0.10 – 4.6 V)” signal
Fuel injector No operation signal from the ECM
Throttle position sensor No signal
Shift position sensor No signal
CMP sensor
(VVT PORT or STBD)
During two crankshaft rotation, 4 signals are not input to ECM.
VVT advance
(PORT or STBD)
There is a large difference between the target advance angle and the
actual advance angle.
Neutral switch While the shift sensor outputs the forward or reverse signal, the ECM
receives input of the neutral signal from the neutral switch.
Model discrimination There is discrepancy of signal between the ECM memory storage and
the model discrimination terminal.
[No.13 terminal open. (DF200)]
[No.13 terminal short circuit. (DF225/250)]
Oil control valve
(PORT or STBD)
OCV not operating.

Table of Contents

Other manuals for Suzuki DF200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki DF200 and is the answer not in the manual?

Suzuki DF200 Specifications

General IconGeneral
BrandSuzuki
ModelDF200
CategoryOutboard Motor
LanguageEnglish

Related product manuals