ENGINE 3-73
NEUTRAL SWITCH
• Install the springs and switch contacts.
• Install the neutral switch.
ENGINE TOP SIDE
PISTON
• Install the piston rings in the order of oil ring, 2nd ring and 1st
ring.
• The first member to go into the oil ring groove is a spacer 1.
After placing the spacer, fit the two side rails 2.
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: Those can be positioned each either way.
• Install the 2nd ring 3 and the 1st ring 4.
NOTE:
1st ring and 2nd ring differ in shape.
• 1st ring has letter “R” marked on the side. Be sure to bring the
marked side to the top when fitting them to the piston.
When installing the spacer, be careful not to allow its
two ends to overlap in the groove.
INCORRECT
CORRECT
1st ring
To Next Page
Loading...
Need help?
General
