15
Right Handlebar Switches
○A Engine Stop Switch
This switch should normally remain in the position for the scooter to operate. In an emergency, switch
to the position to stop the engine.
○B Starter Button
This starter button operates the electric starter when the engine is not running. Turn the ignition switch on;
push this button while holding the front or rear brake lever to start the engine.
Left Handlebar Switches
○A Passing Light Button
When pushing the passing light button , the high beam indicator light goes on to signal the driver of
the vehicle ahead that you are about to pass. The passing light is shut off as soon as the button is
released.
NOTE :
This scooter is equipped with a permanently lit headlight; the headlight (low beam), position light, tail
light, and the license plate light will light up once the ignition switch is turned on and engine started. The
above mentioned lights cannot be turned off.
Do not leave the scooter behind too much time after turning the ignition switch on.