20
Passenger Footrest
This scooter is equipped with 2 passenger footrests ○A . Push ○a the footrests for passenger to use.
7. How to Start the Engine
To Start the Engine
Make sure the engine stop switch is in the position.
Make sure the side stand is up.
Turn the ignition key to “ON” position.
Pull the front or rear brake lever and push the starter button with the completely closed throttle to start
the engine.
To Stop the Engine
Completely close the throttle.
Turn off the ignition switch.
Position the scooter on a firm, level surface with side stand / main stand down.
NOTE :
Fold up the passenger footrests when there is no passenger sitting on the scooter.
CAUTION:
Check the oil and the fuel volume before starting the engine.
Release the starter button immediately after starting the engine.
If the engine cannot be started after activating the starter 3 ~ 5 seconds, please slightly open the
throttle grip then push the starter button to help starting the engine.
Do not push the starter button for more than 10 seconds to prevent damaging the starter.
If the engine cannot be started after several attempts, please turn the ignition switch off and wait
10 seconds for the next start.
Do not push the starter button while the engine is running.
The exhaust gas is toxic; please start the engine in areas with good ventilation.
To Next Page
Loading...
Need help?
General
