10
Standard Operations
Switching the Radio On and Off
Switching the Radio On
Switch the radio on by rotating the volume knob clockwise to about one third of its maximum setting.
The control head display then shows a power-up message.
When first switched on, the radio resumes operation on the same channel as when it was last switched
off.
Press and hold the Monitor (
) key until the indicator flashes. The radio then emits two short
tones. Depress the key briefly to return the radio to the quiet state. The radio then emits a short tone.
You may need to finally set the volume level when you receive your first call.
Switching the Radio Off
Switch the radio off by rotating the volume knob anticlockwise, to its primary position.
The T2020
II
retains some settings that are used when it is switched on again.
Selecting a Channel or a Group
Selecting a Channel
When first switched on, the radio resumes operation on the same channel as when it was last switched
off.
To check the current channel:
●
Select Channel mode by pressing the Channel (
) key, and the current channel name
appears in the display window.
To select a new channel:
●
Press the Up and Down ( / ) scroll keys on the keypad to move through the list of the
available channels, until the display shows the identity of the required channel, or
●
Use the numeric keypad to enter a new channel number, then press the Enter ( ) key, or
●
Use the alphanumeric keypad to enter an alphanumeric label, then press the Enter ( ) key
to initiate the call.
To Next Page
Loading...
Need help?
General
