24
3. Press the Enter key, and the caller identity of the entry in the display window appears. Again, you
can use the Up and Down keys to scroll through the list of entries, and the Zero key to delete the
entry from the queue.
4. Press the Enter key again when the caller identity of the entry is being displayed, and call-back is
initiated. The entry is then automatically removed from the queue. Note that the call-back se-
quence is based on the caller identity.
Exiting the Call Queue
Exit Call Queue Entry mode by pressing any mode key, including the Function (
Fn
) key.
The radio automatically exits from Call Queue Entry mode, and reverts to the Function menu, if the last
entry in the call queue is deleted. This can be done either by using the Zero key, or making a call-back.
Queuing Calls
The caller identity and the channel of the received call is put in the call queue when:
●
The internal alert (ringing) of the received call stops
●
Another call is received before the previous one is queued.
Note:
After the incoming call has been queued, it is automatically cleared or answered, and the radio
resumes what it was doing prior to receiving the call. This includes the resumption of scanning,
if the radio was scanning prior to receiving the call.
Call Queue Full
Whenever the queue is full, the radio continues to receive calls, but does not resume what it was doing
prior to receiving the call (e.g. scanning). This allows calls to be received only on the held channel.
Subsequent calls that are received overwrite the information about the previous call.
To Next Page
Loading...
Need help?
General
