18 Replacing the Network Board TB9100 Reciter Service Manual
© Tait Electronics Limited January 2006
1.6 Restoring the Configuration
1. Connect the CSS to the reciter using the correct IP address (network
boards are given the IP address 192.168.1.2 in the factory.)
2. Restore the base station’s configuration, overwriting the IP address.
3. Reset the reciter. On power-up, the reciter uses the new IP address.
4. Use the procedures in the Troubleshooting section above to verify
correct operation of the network board.
To Next Page
Loading...
Need help?
General
