TC-Helicon VoiceLive Touch2 User Manual

5
usinG the slider fX bar
Using the Slider FX Bar: swiping
A quick flick along the Slider FX Bar (13) will start it freewheeling through
the parameter values or presets. A single tap during freewheeling will
stop scrolling.
Using the Slider FX Bar: dragging and tapping
Moving your finger along the Slider FX Bar slowly without releasing is
useful for a small range of values. You can also tap just to the left or right
of the center to increment or decrement by one value.
5. Voices: Tap the Voices button to display the Harmony voice
intervals for the current preset and the HARMONY LEVEL Slider
FX assignment. To hear the voices created by the VoiceLive
Touch2, the HARM (Harmony) effect must be active.
6. Tap: Tap this button rhythmically to set the global tempo for the
Delay effects, the Rhythm effects and the Loop metronome.
7. Setup: Tap the Setup button to adjust global settings such as
stereo/mono output mode, MIDI channel etc. and to enable mi-
crophone phantom power (by setting Input to “Condenser”).
8. Mix: Tap the Mix button to display the global audio levels. Tap
the Mix button again to switch between the two menu pages.
Individual effects levels within presets are not adjusted here – this is
done in the Edit menus.
9. Loop: Tap the Loop button to display the loop options and the
effect assigned to the Slider FX Bar in Loops mode. Tap again to
display the advanced loop menu.
10. Play & Record: These are the Loop transport controls that are
active in all modes.
11. Hit / Hold for talk: Tap the Hit button to activate one or mul-
tiple effects in a preset with a single tap. To see what effects are
used when Hit is on or off, tap the Effects button, then tap the Hit
button a couple of times. To edit the effects status for each state
(Hit on / Hit off), tap the respective Matrix buttons.
For descriptions of (12) to (15), please see the following sections.
Front panel

TC-Helicon VoiceLive Touch2 Specifications

Analog Inputs

mic input impedance	3.08/1.54 kOhm
mic input level at 0 dBFS	-42 dBu to +4.2 dBu
mic equivalent input noise at max mic gain Rg = 150 Ohm	-127 dBu
mic signal-to-noise ratio	>100 dB
guitar input impedance	1 MOhm
guitar input level at 0 dBFS	-7 dBU to 17 dBu
guitar input signal-to-noise ratio	>108 dB
aux input level at 0 dBFS	+2 dBu
analog to digital conversion	24 Bit, 128 x oversampling bitstream, 110 dB SNR A-weighted

Analog Outputs

output impedance balanced/unbalanced	80/40 Ohm
output range line	+2 dBu
dynamic range	>109 dB, 20 Hz to 20 kHz
frequency response	+0/-0.3 dB, 20 Hz to 20 kHz
headphone out	+17 dBu max (50 mW max)
digital to analog conversion	24 Bit, 128 x oversampling bitstream, 115 dB SNR A-weighted

Power

external power supply	100 to 240 VAC, 50 to 60 Hz (auto-select)
power consumption	<14 W

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity max	90 % non-condensing

Size and Weight

dimensions	9” x 4” x 7” (230 x 100 x 180)
weight	5 lb. (2.3 kg)