TCL u Series User Manual

13
6. Operations
6.1 Power On
Controller will display as below
Display input type
(K2)
Display range
(0.0~400.0)
Ready for use
All LED and 7 segment
displays will be lighted
6.2 Change the Set Value (SV)
Change SV from 0.0 to 100.0
Press key. The SV
number started to flash.
The flashing digit indicates
which digit can be set.
Press key
to select the hundreds digit.
Press key
to change the number to 1
Press key
to store the new
set value.
SET
6.3 Change the Alarm Value
Change AL1 value to “5.0” (AL1 active, if PV exceeds SV over 5.0)
Press key
to display parameter AL1
Press key
to change AL1 value
Press key
increase AL1 value
Press key
store the new value
of AL1
SET
SET
* The are total 16 alarm mode types, please referred with “alarm mode” in page 30
* To change alarm mode, press
SET
+ key 5 seconds to enter Level 3 (Input
Level) and then change ALD1/ALD2/ALD3 value.

TCL u Series Specifications

General

Brand	TCL
Model	u Series
Category	Controller
Language	English