'art I
SoundsandeUects
DigitalReverb(PR250/PR350)
Q.;315
IE
".;.. 666S"S"oEai50CS:-. 6tH °*350 --
~
. -
I
- -
~ - ~ ~~ - . ...-:,L,;J . . . . 000300 ::00 ,. ~O .
0 - ,-,c::J.~' I;)0 00 "G..:;. .~ OO~::ioooo~ 0000 '-"5 ~__'~'Ol
DIGITAL REVERB applies a reverberation effect
to the sound. Select from three types:
. ROOM is minimum;
. STAGE is medium;
. HALL is the maximum amount of this effect.
. These effects work for all generated sounds,
including those of the rhythm pattern instru-
ments.
DIGITAL REVERB
ROOM STAGE HALL
0 0 0
000
~
Press the button for the desired type of reverb to
turn it on.
. The total depth of the reverb can be adjusted.
(Refer to page 37.)
Mixingtwosounds
You can play two completely different sounds at
the same time. To accomplish this effect, just
press the two buttons for the desired sounds
simultaneously.
Volumebalance
You can adjust the volume balance between two
sounds when they are mixed together by following
this proced"ure:
1. Press and hold the button for the first sound.
2. While holding down the button for the first
sound, press and hold the button for the second
sound. The second sound you select is the one
whose volume level can be adjusted.
3. After approximately 3 seconds, the indicator
for the second sound you selected will flash.
This is your visual signal that you can adjust
the volume for this sound.
4. Adjust the volume of the second sound by using
the TRANSPOSE/PROGRAM's UP and DOWN
buttons. MUSICAL DISPLAY
,-
]
0
TRANSPOSEf
0 PROGRAM 0
n-
Gup
n
. The number of notes which can sound simul-
tanously is reduced to 16.
5. Press any button in the SOUND SELECT sec-
tion to exit the volume-balance-setting mode.
. The volume increases each time the UP button
is pressed and decreases each time the DOWN
button is pressed.
. There are 10 different levels of volume for the
selected sound (0-9). The selected level is
shown on the display.
. You can confirm the volume by playing the
keyboard.
. The volume level which is set in this manner
is recalled only when the sound is selected as
the second of two mixed sounds. Specify the
second sound by pressing its button slightly
after pressing the button for the first sound.
. To return the volumes to the factory-preset
levels, follow the initialization procedure on
page 40.
. The SOUND VARIATION indicator remains
unlit when the sounds are mixed even if
SOUND VARIATION is selected for the sound.
6
To Next Page
Loading...
Need help?
General
