Issue/Rev. 0.4 (6/17) ║ MN03010 • Page 11
Figure 5 – Cover Disassembly
Caution!
The cover spring(s) could cause the cover to release from the body unexpectedly.
However, if the cover does not release from the body, use two flat headed screw-
drivers to pry down, against the body as shown below. Ensure to only insert the tip
of the screwdrivers underneath the rabbit and not to pry against the diaphragm.
Depending on valve size, there could be two springs underneath the cover – 2”
and 3” valves have one spring while 4” and 6” valves have two springs.
Figure 6 – Cover Removal
Model 210 Valve (I / O / S) Manual Service and Maintenance
To Next Page
Loading...
Need help?
General
