Page 4 • MN03010 ║ Issue/Rev. 0.4 (6/17)
Model 210 Valve (I / O / S) Manual General
1 – General
The Smith Meter
®
Model 210 Digital Control Valves are hydraulically-operated,
diaphragm-controlled valves, typically used in conjunction with either an AccuLoad
or microLoad.
1.1 Receipt of Equipment
When the equipment is received, the outside packing case should be checked
immediately for any shipping damage. Carefully remove the unit from its packing
case and inspect for damaged or missing parts. If damage has occurred during
shipment or parts are missing, the local carrier should be notified immediately and
a written report should be submitted to the Customer Service Department, FMC
Technologies Measurement Solutions, Inc., P.O. Box 10428, Erie, Pennsylvania
16514-0428. Prior to installation the unit should be stored in its original packing
case and protected from adverse weather conditions and abuse.
Standard explosion proof solenoids are:
UL listed and CSA certified for use in Class I, Groups C and D, Division 1.
Class II, Groups E, F, and G, Division 1 hazardous locations.
1.2 Installation
Ensure the valve is installed with flow in the correct direction. The intended flow
direction is indicated on the side of the valve body.
These products have been designed for petroleum applications, where corrosion/
erosion is normally minimum. The design of the pressure containing housings have
adequate material allowance for typical petroleum applications. Consult the factory
for other applications or for the actual material allowances.
1.3 Electrical
Wiring is covered in the appropriate controller manual:
MN06150 microLoad.net (I)
MN06037 AccuLoad II (I)
MN06135 AccuLoad III (I)
MN06140 AccuLoad III.SA (I)
MN06143 AccuLoad III-N4 (I)
MN06201 AccuLoad IV (I/M)
To Next Page
Loading...
Need help?
General
