Commands Listed in Alphabetical Order
Group
Vertical
Syntax
CH<x>:PRObe:SIGnal {BYPass|PASS}
CH<x>:PRObe:SIGnal?
Arguments
BYPass sets the probe to Bypass mode.
PASS sets the probe to Pass mode.
CH<x>:PRObe:UNIts? (Query Only)
Returns a string describing the units of measure for the probe attached to channel
<x>, where x is the channel number.
Group
Vertical
Syntax
CH<x>:PRObe:UNIts?
Examples
CH4:PROBE:UNITS? might return :CH4:PROBE:UNIT S "V" indicating that the
units of measure for the probe attached to channel 4 are volts.
CH<x>:SCAle
Sets or returns the vertical scale for the channel specified by <x>, where x is the
channel number.
Each waveform has a vertical scale parameter. For a signal with constant
amplitude, increasing the Scale causes the waveform to be displayed smaller.
Decreasing the scale causes the waveform to be displayed larger.
Scale affects all waveforms, but affects channel waveforms differently from
other waveforms:
For channel waveforms, this setting controls the vertical size of the acquisition
window as well as the display scale. The range and resolution of scale
values depends on the probe attached and any other external factors you have
specified.
For reference and math waveforms, this setting controls the display only,
graphically scaling these waveforms and having no affect on the acquisition
hardware.
Group
Vertical
2-108 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
