Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Conditions
This feature re
quires installation of a DPO4AUTO or DPO4AUTOMAX
application module for MDO4000C models, or MDO3AUTO for MDO3000
models.
Group
Bus
Syntax
BUS:B<x>:CAN:STANDard
BUS:B<x>:CAN:STANDard{CAN2X|CANFD} string
BUS:B<x>:CAN:STANDard?
Arguments
CAN2X sets the CAN bus standard to CAN 2.0
CANFD sets the CAN bus standard to CAN FD
Examples
BUS:B1:CAN:STANDard CANFD sets the CAN bus standard to CAN FD.
BUS:B1:CAN:STANDard? might return CAN2X, indicating that the CAN bus
standard is CAN 2.0.
BUS:B<x>:DISplay:FORMat
Specifies the display format for the numerical information in the bus waveform.
The display formats supported depend on the BUS:B<x>:TYPe.
Table 2-51: Supported display formats
Bus type Display format
Audio
BINary | HEXadecimal | AS CII | SIGNEDDECimal
1
CAN BINary | HEXadecimal | MIXed
Ethernet
BINary | HEXadecimal | ASCII | MIXed
FlexRay
BINary | HEXadecimal | MIXed
I
2
C BINary | HEXadecimal
LIN
BINary | HEXadecimal | MiXed
MIL-STD-1553 BINary | HEXadecimal | ASCII|MIXed|BLOCKHEX
Parallel
BINary | HEXadecimal
RS232C BINary | HEXadecimal | ASCII
SPI BINary | HEXadecimal
USB BINary | HEXadecimal | MIXed | MIXED2
1
SIGNEDDECimal is set using the audio application BUS:B<x>:AUDio:DISplay:FORMat command.
Group
Bus
2-172 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English