Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Group
Cursor
Syntax
CURSor:XY:POLar:THETA:UNIts?
CURSor:XY:PRODUCT:DELta? (Query Only)
Returns the difference between the cursors X position and cursor Y position. The
ΔX × ΔY value is calculated as (X2 - X1) × (Y2 - Y1).
Group
Cursor
Syntax
CURSor:XY:PRODUCT:DELta?
CURSor:XY:PRODUCT:POSITION<x>? (Query Only)
Returns the position of the X or Y cursor used to calculate the X × Y cursor
measurement, Position 1 = (X1 × Y1); Position 2 = (X2 × Y2). The cursor is
specified by x, which can be 1 or 2.
Group
Cursor
Syntax
CURSor:XY:PRODUCT:POSITION<x>?
CURSor:XY:PRODUCT:UNIts? (Query Only)
Returns the XY cursor product units.
Group
Cursor
Syntax
CURSor:XY:PRODUCT:UNIts?
CURSor:XY:RATIO:DELta? (Query Only)
Returns the ratio of the difference between the cursors X position and cursor Y
position (ΔY¸ ΔX). The ratio is calculated as (Y2 - Y1) / (X2 - X1).
Group
Cursor
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-267

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English