Commands Listed in Alphabetical Order
Table 2-53: DATa and WFMOutpre Parameter Settings (cont.)
WFMOutpre Settings
DATa:ENCdg
Setting :ENCdg :BN_Fmt :BYT_Or :BYT_NR
RIBinary BIN RI
MSB
1,2
RPBinary BIN RP
MSB
1,2
SRIbinary
BIN RI
LSB
1,2
SRPbinary
BIN RP
LSB
1,2
FPbinary BIN FP
MSB
4
SFPbinary
BIN FP
LSB
4
Examples
DATA:
ENCDG?
might return :DATa:ENCD G SRPBINARY for the format of the
outgoing waveform data.
DATA:ENCDG RPBinary sets the data encoding format to be a positive integer
where the most significant byte is transferred first.
DATa:SOUrce
This command specifies the source waveform to be transferred from the
oscilloscope using the
CURVe? query. The valid waveform sources are CH1-CH4,
MATH, R EF1-REF4, D0-D15, DIGital, RF_AMPlitud e, RF_FREQuency,
RF_PHASe, RF_NORMal, RF_AVErage, RF_MAXHold, and RF_MINH old.
Setting DATa:SOUrc e automatically constrains the following to valid values for
thespecifiedsourcewaveform:
WFMOutpre:BYT_N
r, WFMOu tpre:BIT_Nr
and
WFMOutpre:BN_Fmt.
(See page 2-95, Waveform Transfer Command Group.)
Group
Wavef
orm Transfer
Syntax
DATa:SOUrce
{CH1|CH2|CH3|CH4|MATH|REF1|REF2|REF3|R EF4|D0|D1|D2|D3
|D4|D5|D6|D7|D8|D9|D10|D11|D12|D13|D14 |D15|DIGital
|RF_AMPlitude|RF_FREQuency|RF_PHASe|RF _NORMal|RF_AVErage|
RF_MAXHold|RF_MINHold}
DATa:SOUrce?
Related Commands
CURVe
Arguments
CH1–CH4 specifies which analog channel waveform data will be transferred from
the oscilloscope to the controller, channels 1 through 4.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-277
To Next Page
Loading...
Need help?
General
