Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:CAN:DATa:QUALifier
{LESSthan|MOREthan|EQual|UNEQual|LESSE Qual|EQual}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CA N:DATa:QUALifier?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue
Arguments
LESSthan searches for bus data less than the value specified by
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue.
MOREthan searches for bus data greater than the value specified by
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue.
EQual searches for bus data equal to the value specified by SEARCH:
SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue.
UNEQual searches for bus data not equal to the value specified by
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue.
LESSEQual searches for bus data less equal to the value specified by
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue.
EQual searches for bus data equal to the value specified by SEARCH:
SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:VALue.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CAN:DATa:SIZe
This command sets the length of the data string, in bytes, to be used to search
on CAN bus data. This only applies if the search condition has been set to
IDANDDATA or DATA (using SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:
CAN:CONDition).
SEARCH<x> is the search number, which is always 1, and B<x> is the bus number
(1-4). 1-3 for the MDO4000C and 1-2 for the MDO3000.
Conditions
This command requires a DPO4AUTO or DPO4AUTOMAX applic
ation module
on DPO/MSO4000B and MDO4000/B/C models and a MDO3AUTO application
module on MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CA N:DATa:SIZe <NR1>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:CA N:DATa:SIZe?
Arguments
<NR1> is the data string length in bytes.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-627
To Next Page
Loading...
Need help?
General
