Commands Listed in Alphabetical Order
Conditions
MDO3000 series
. Requires option SA3 or SA6 for the MDO4000C series.
Requires the DPO4VID application module for use with MSO/DPO4000B,
MDO4000 and MDO4000B models.
Group
Video Picture
Syntax
VIDPic:STANdard {NTSC|PAL}
VIDPic:STANdard?
Arguments
NTSC sets the video picture standard to NTSC (National Television Systems
Committee).
PAL sets the video picture standard to PAL (Phase Alternation Line).
Examples
VIDP:STAN PAL sets the video picture standard to PAL.
*WAI (No Query Form)
Prevents the oscilloscope from executing further commands or queries until all
pending commands that generate an OPC message are complete. This command
allows you to synchronize the operation of the oscilloscope with your application
program.(See page 3-7, Synchronization Methods.)
The
*WAI command will stop execution until certain oscilloscope operations are
complete. (See Table 3-3 on page 3-8.)
Group
Status and Error
Syntax
*WAI
Related Commands
BUSY?,
*OPT?
Examples
*WAI prevents the oscilloscope from executing any further commands or queries
until all pending commands that generate an OPC message are complete.
WAVFrm? (Query Only)
This query returns the waveform preamble and the waveform data for the source
waveform specified by the
DATa:SOUrce command. This command is equivalent
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-943
To Next Page
Loading...
Need help?
General
